SECTION I 

AFC INTERNATIONAL PTY. LIMITED.

21-23 Hobart Street, Riverstone, New South Wales 2765, Australia

TELEPHONE: 02 9627 7125  FAX: 02 9627 7126 

Product Name:         DynaGrip 5-Minute Epoxy Adhesive – Part A Resin followed by Part B 

Product Code:          49409

Chemical Family:     Epoxy Resin

Chemical Name:       Diglycidylether of Bisphenol-a

SECTION 2 – COMPOSITION/INFORMATION ON INGREDIENTS 

Ingredient          % (optional)          CAS Number           OSHA PEL mg/m³                         ACGIH TLV-TWA mg/m³

Epoxy Resin                                  025085-99-8             Not Established                    Not Established

Contains no hazardous chemicals in excess if 1% as indicated by supplier’s material safety data sheets
and OSHA’s hazardous chemicals standards.

SECTION 3 – HAZARDS IDENTIFICATION

Boiling Point (DEG F):                N/A

Specific Gravity (Water-1):          1.16

Vapour Pressure (mm Hg):         N/A                  

Percent Volatile by Volume:        0.0

Vapour Density (Air-1):               N/A                  

Evaporation Rate Vs Ether:         N/A

Solubility in Water:                     No                   

Appearance and Odour:              Straw colored liquid, sweet characteristic odour

SECTION 4 – FIREFIGHTING MEASURES

Flash Point (Method Used):                    251°C (485 °F) (PMCC)

Flammable Limits:                                 Not Determined

Extinguishing Media:                              Use Water Spray, Dry Chemical, Foam or Carbon Dioxide

Special Fire Fighting Procedures:            Treat As A Class B Fire

Unusual Fire and Explosion Hazards:      None

SECTION 5 – FIRST AID MEASURES

Effects of Overexposure:

INGESTION:  LOW ACUTE ORAL TOXICITY LD50 (RAT) GREATER THAN 2000 MG/KG.
EYE CONTACT:  MINOR TRANSIENT IRRITATION.  NO CORNEAL INJURY LIKELY.
SKIN CONTACT:  ONLY MINOR IRRITATION.  MAY BE A SKIN SENSITIZER.
SKIN ABSORPTION:  NOT LIKELY TO BE ABSORBED THROUGH SKIN IN TOXIC AMOUNTS.
INHALATION:  NOT CONSIDERED A PROBLEM UNLESS HEATED TO HIGH TEMPERATURE.

Emergency First Aid Procedures

SKIN CONTACT:  WASH WITH SOAP AND WATER; WASH CLOTHES BEFORE REUSE.
EYE CONTACT:  IRRIGATE WITH WATER FOR FIVE MINUTES; CONSULT PHYSICIAN.
INHALATION:  REMOVE TO FRESH AIR IF EFFECTS OCCUR; CONSULT PHYSICIAN.
INGESTION:  INDUCE VOMITING IF LARGE AMOUNTS ARE INGESTED.

SECTION 6 – STORAGE AND HANDLING

Steps to be taken if Released or Spilled:
ABSORB WITH INERT MATERIAL (SAND, VERMICULITE, ETC.)
SWEEP OR SCOOP UP AND PUT IN DISPOSAL CONTAINER.
FLUSH AREA IMMEDIATELY WITH PLENTY OF WATER; PREVENT WASHINGS FROM ENTERING WATERWAYS.

Waste Disposal Method:
INCINERATE IN FURNACE OR BURY IN LANDFILL IN ACCORDANCE WITH FEDERAL, STATE, AND LOCAL REGULATIONS.

SECTION 7 – EXPOSURE CONTROL/PERSONAL PROTECTION

Respiratory Protection:
NIOSHA APPROVED ORGANIC VAPOUR RESPIRATORS ARE ONLY REQUIRED WHEN VENTILATION IS INADEQUATE.
NIOSHA APPROVED AIR-LINE RESPIRATORS WITH AUXILIARY ESCAPE AIR TANKS OR SELF-CONTAINED
BREATHING APPARATUS SHOULD BE USED IN CONFINED SPACES.

Ventilation:  LOCAL MECHANICAL EXHAUST.

Protective Gloves:  IMPERVIOUS GLOVES.

Eye Protection:  SAFETY GLASSES WITH SIDE SHIELDS.

Other Protective Equipment:  SAFETY SHOWER AND EYE BATH SHOULD BE PROVIDED.
USE COVERALLS OR APRON TO PROTECT AGAINST SKIN AND CLOTHING CONTAMINATION.

SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES

Precautions to be Taken in Storage and Handling: PRACTICE REASONABLE CARE AND CLEANLINESS.

Other Precautions:
AVOID GROSS CONTAMINATION OF SKIN.
WASH SKIN WITH PLENTY OF SOAP AND WATER.
USE WITH ADEQUATE VENTILATION.
AVOID BREATHING VAPOURS.

SECTION 10 – STABILITY AND REACTIVITY 

Stability:  STABLE
Incompatibility (Materials to Avoid): Strong Acids, Amines, Mercaptons, Bases (In Uncontrolled Amounts)
Hazards Decomposition Products:  Thermal Decomposition May Produce Carbon Monoxide and/or Carbon Dioxide
Hazard Polymerization:  Will Not Occur.
Conditions to Avoid:  Strong Acids, Amines, Mercaptons, Bases (In Uncontrollable Amounts)

SECTION 11 – OTHER INFORMATION 

N/A - Indicates That This Specification Does Not Apply To This Product

PART B. 

SECTION 1 – CHEMICAL PRODUCT IDENTIFICATION

Product Name:         DynaGrip 5-Minute Epoxy Adhesive – Part B Adhesive

Product Code:          49409

Chemical Family:     Epoxy Curing Agent

Chemical Name:       Polymercaptan

SECTION 2 – COMPOSITION/INFORMATION ON INGREDIENTS

Ingredient          % (optional)          CAS Number           OSHA PEL mg/m³                         ACGIH TLV-TWA mg/m³

Mercaptan Polymer                       Trade Secret              Not Established                    Not Established

SECTION 3 – HAZARDS IDENTIFICATION 

Boiling Point (DEG F):                >260°C (>500 °F)         

Specific Gravity (Water-1):          1.15

Vapour Pressure (mm Hg):         N/A                  

Percent Volatile by Volume:        0.0

Vapour Density (Air-1):               N/A                  

Evaporation Rate Vs Ether:         Less Than

Solubility in Water:                     Slight               

Appearance and Odour:              Amber Liquid, Sulphorous Odour.

SECTION 4 – FIREFIGHTING MEASURES

Flash Point (Method Used):                    257°C (495 °F) (COC)               

Flammable Limits:                                 Not Determined

Extinguishing Media:                              Use Water Spray, Dry Chemical, Foam or Carbon Dioxide

Special Fire Fighting Procedures:            Treat As A Class B Fire:  Use Water to Cool Containers

Unusual Fire and Explosion Hazards:      None

SECTION 5 – FIRST AID MEASURES 

Effects of Overexposure:

INGESTION:  LOW ACUTE ORAL TOXICITY.
EYE CONTACT:  EXTREMELY IRRITATING WITH POSSIBLE EYE INJURY.
SKIN CONTACT:  OVEREXPOSURE COULD CAUSE BURNS OR BLISTERING.
SKIN ABSORPTION:  NOT LIKELY TO BE ABSORBED THROUGH SKIN IN TOXIC AMOUNTS.
INHALATION:  NOT CONSIDERED A PROBLEM UNLESS HEATED TO HIGH TEMPERATURE.

Emergency First Aid Procedures:

SKIN CONTACT:  WASH WITH SOAP AND WATER; WASH CLOTHES BEFORE REUSE.
EYE CONTACT:  IRRIGATE WITH WATER FOR FIFTEEN MINUTES; CONSULT PHYSICIAN.
INHALATION:  REMOVE TO FRESH AIR IF EFFECTS OCCUR; CONSULT PHYSICIAN.
INGESTION:  DO NOT INDUCE VOMITING: GIVE LARGE QUANTITIES OF WATER: GIVE 28 GRAMS
(1 OUNCE) VINEGAR IN 28 GRAMS (1 OUNCE) WATER. CONSULT PHYSICIAN. 

SECTION 6 – STORAGE AND HANDLING

Steps to be taken if Released or Spilled:
ABSORB WITH INERT MATERIAL (SAND, VERMICULITE, ETC.)
SWEEP OR SCOOP UP AND PUT IN DISPOSAL CONTAINER.
FLUSH AREA IMMEDIATELY WITH PLENTY OF WATER;
PREVENT WASHINGS FROM ENTERING WATERWAYS.

Waste Disposal Method:
INCINERATE IN FURNACE OR BURY IN LANDFILL IN ACCORDANCE WITH FEDERAL, STATE, AND LOCAL REGULATIONS.

SECTION 7 – EXPOSURE CONTROL/PERSONAL PROTECTION

Respiratory Protection:
NIOSHA APPROVED ORGANIC VAPOUR RESPIRATORS ARE ONLY REQUIRED WHEN VENTILATION IS INADEQUATE.
NIOSHA APPROVED AIR-LINE RESPIRATORS WITH AUXILIARY ESCAPE AIR TANKS OR SELF-CONTAINED BREATHING
APPARATUS SHOULD BE USED IN CONFINED SPACES.

Ventilation:  LOCAL MECHANICAL EXHAUST.

Protective Gloves:  IMPERVIOUS GLOVES.

Eye Protection:  SAFETY GLASSES WITH SIDE SHIELDS.

Other Protective Equipment:  SAFETY SHOWER AND EYE BATH SHOULD BE PROVIDED.
USE COVERALLS OR APRON TO PROTECT AGAINST SKIN AND CLOTHING CONTAMINATION.

SECTION 8 – PHYSICAL AND CHEMICAL PROPERTIES

Precautions to be Taken in Storage and Handling: PRACTICE REASONABLE CARE AND CLEANLINESS.

Other Precautions:  AVOID GROSS CONTAMINATION OF SKIN.
WASH SKIN WITH PLENTY OF SOAP AND WATER.
USE WITH ADEQUATE VENTILATION.  AVOID BREATHING VAPOURS.

SECTION 9 – STABILITY AND REACTIVITY

Stability:  STABLE
Incompatibility (Materials to Avoid): Strong Oxidizers
Hazards Decomposition Products:  Decomposition May Produce Carbon Monoxide and/or Carbon Dioxide.
Hazard Polymerization:  Will Not Occur.
Conditions to Avoid:  Oxidizing Materials.

SECTION 10 – OTHER INFORMATION

N/A - Indicates That This Specification Does Not Apply To This Product

SECTION 11.  PREPARATION INFORMATION

POISONS INFORMATION CENTRE 

Adelaide:                (08) 8204-6117      Brisbane:               (07) 3253-8233

Canberra:              (02) 6285-2852      Darwin:                  (08) 8922-8842      

Hobart:                   (03) 6338-8485      Melbourne:             (03) 9345-5678

Perth:                     (08) 9381-1177      Sydney:                  (02) 9692-6111  

POLICE OR FIRE BRIGADE:   000                    EXCHANGE:  1100

Information presented herein has been complied from sources considered to be dependable and is accurate and reliable to the best of our knowledge and belief but is not guaranteed to be so. Nothing herein is to be constructed as recommending any practice or any product in violation of any patent or in violation of any law or regulation. It is the user's responsibility to determine for himself the suitability if any material for a specific purpose and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and, since conditions of use are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us.

ISSUE DATE: 01/02/2003