Material Safety Data Sheet

AFC INTERNATIONAL PTY. LTD. Ph: 02 9627 7125 Fax: 02 9627 7126

SECTION I

Company Address: 21-23 Hobart Street, Riverstone, New South Wales 2765, Australia

Chemical name and synonyms: STRUCTURAL COMPOSITIONS
Chemical family: METHACRYLATE ESTERS

DYNAGRIP REAR VIEW MIRROR ADHESIVE

Part Number: 49401

PERSONAL PROTECTION: SEE SECTION 8

HMIS/NFTA: Flammability: LOW(1) Health: Moderate(2) Reactivity: LOW(1) Specific Hazard: MILD SKIN IRRITANT

SECTION II-HAZARDOUS INGREDIENTS

Hazardous Mixtures of Other Liquids, Solids, or Gases
CARCINOGENIC
CAS NO. % NTP IARC OSHA
POLYURETHANE METHACRYLATE Proprietary 50-55 NO NO NO
HYDROXYALKYL METHACRYLATE 27813-02-1 35-40 NO NO NO
ACRYLIC ACID** 79-10-7 5-10 NO N/A NO
CUMENE HYDROPEROXIDE** 80-15-9 1-3 NO NO NO
SUBSTITUTED SILANE 2530-83-8 0.1-1 NO NO NO
SACCHARIN* 81-07-2 0.1-1 YES 2B NO
*2B--POSSIBLY CARCINOGENIC TO HUMANS.
**THIS COMPONENT IS LISTED AS A SARA SECTION 313 TOXIC CHEMICAL.

SECTION III-PHYSICAL DATA

Boiling point: >150°C (>300°F)
Specific Gravity: 1.1 (H2O=1)
Vapour Pressure: 10mm at 26.6°C (80°F)
Percent Volatile, by volume: 49%
Vapour Density: N/A
Evaporation Rate: N/A
Solubility in Water: INSOLUBLE
Appearance and Odour: YELLOW LIQUID, SHARP IRRITATING ODOUR

SECTION IV-FIRE AND EXPLOSION HAZARD DATA

Flash Point: >93°C (>200°F) (method used-C.O.C.)
Flammable Limits: LEL: 2.0 UEL: 8.0
Extinguishing Media: CARBON DIOXIDE, DRY CHEMICAL, WATER
Special Fire Fighting Procedures: SELF CONTAINED BREATHING APPARATUS
Unusual Fire and Explosion Hazards: IRRITATING ORGANIC VAPOURS

SECTION V-HEALTH HAZARD DATA

Threshold Limit Value: Acrylic Acid: 2ppm TWA skin(ACGIH), 10ppm TWA skin(OSHA)
Effects of Overexposure: PROLONGED SKIN CONTACT MAY RESULT IN DERMATITIS IN SENSITIVE PERSONS. WILL IRRITATE EYES ON CONTACT.
Emergency and First Aid Procedures: WASH WITH SOAP AND WATER FOR SKIN CONTACT. FOR EYE CONTACT, FLUSH WITH PLENTY OF WATER. FOR INGESTION, DO NOT INDUCE VOMITING. CONTACT PHYSICIAN.

SECTION VI-REACTIVITY DATA

Stability: STABLE
Incompatibility (Materials to avoid): AVOID CONTAMINATION WITH BASE MATERIALS
Hazardous Decomposition Products: NONE (NON-THERMAL)
Hazardous Polymerization: WILL NOT OCCUR
Conditions to avoid: TEMPERATURES IN EXCESS OF 65°C (150°F)

SECTION VII-SPILL OR LEAK PROCEDURES

Steps to be taken in case material is released or spilled: SOAK UP WITH INERT ABSORBENT.
Waste disposal method: LANDFILL OR INCINERATE IN ACCORDANCE WITH EPA AND LOCAL REGULATIONS.

SECTION VIII-SPECIAL PROTECTION INFORMATION

Respiratory protection (type): NONE NEEDED FOR NORMAL USE.
Ventilation: MECHANICAL VENTILATION NOT NORMALLY REQUIRED. ENSURE ADEQUATE ROOM VENTILATION FOR COMFORTABLE WORKING CONDITIONS.
Protective Gloves: POLYETHYLENE OR RUBBER GLOVES.
Eye Protection: SAFETY GLASSES.
Other protective equipment: BARRIER CREAMS RECOMMENDED.

SECTION IX-SPECIAL PRECAUTIONS

Precautions to be taken in handling and storage: STORE IN A COOL DRY PLACE AND OUT OF DIRECT SUNLIGHT.

Other precautions: KEEP AWAY FROM CHILDREN.

CONTACT POINT:

POISONS INFORMATION CENTRE

Adelaide: (08) 8204-6117 Brisbane: (07) 5253-8233
Canberra: (02) 6285-2852 Darwin: (08) 8922-8842
Hobart: (02) 6338-8485 Melbourne: (03) 9345-5678
Perth: (08) 9381-1177 Sydney: (02) 9692-6111

POLICE OR FIRE BRIGADE: 000 EXCHANGE: 1100
Information presented herein has been complied from sources considered to be dependable and is accurate and reliable to the best of our knowledge and belief but is not guaranteed to be so. Nothing herein is to be constructed as recommending any practice or any product in violation of any patent or in violation of any law or regulation. It is the user's responsibility to determine for himself the suitability if any material for a specific purpose and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and, since conditions of use are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us.

REVISED 01/07/2001