No.2 GASKET SEALER

Material Safety Data Sheet

AFC INTERNATIONAL PTY. LTD. Ph: 02 9627 7125  Fax: 02 9627 7126

MATERIAL SAFETY DATA SHEET

GASKET SEALANT NO.2
PART NOS. 49302. 49311, 49343

SECTION I - PRODUCT IDENTIFICATION

Product Name    :     Gasket Maker #2
Product Type    :     Sealant

SECTION II - HAZARDOUS INGREDIENTS

INGREDIENTS                   CAS NO.     OSHA     ACGIH    HAZARD         WG%
Isopropyl Alcohol              67-63-0           400             400      FLAMMABLE     7.4
1-Methoxy 2-Propanol     107-98-2        100             100      FLAMMABLE       .3
Ammonia                           7664-41-7        750              750     FLAMMABLE       .3

SECTION III - NON - HAZARDOUS INGREDIENTS

INGREDIENTS            CAS NO.
Castor Oil                      8001-79-4
ASP 600                         1327-38-2
Calcium Carbonate     471-34-1
Lamp Black                  7440-44-0
Water

SECTION IV - CHEMICAL AND PHYSICAL PROPERTIES

Vapour Pressure     :     29MM @ 360oC (68oF)
Vapour Density     :     2.5
Solubility in Water     :     .86
Specific Gravity     :     1.25
Boiling Point     :     1700F
pH     :     N/A
Odour     :     Mild
Appearance     :     Black Paste

SECTION V - FLAMMABILITY AND EXPLOSIVE PROPERTIES

Flash Point     :     540F ASTM D93-71
Method Used     :     Closed Cup
Explosive Limits (% by Volume in Air)     :      Lower - 3% Upper - 20%
Extinguishing Media     :     C02, Dry Chemical and foam.
Hazardous Products Formed by Fire or Thermal Decomposition :     Carbon Dioxide and Carbon Monoxide
Unusual Fire & Explosion Hazards     :      None

SECTION VI - TOXICITY AND HEALTH HAZARD DATA

Toxicity     :     Eye irritant - Moderately Toxic by Ingestion
CARCINOGENICITY
    NTP     :     No
    IARC Monographs     :     No
    OSHA Regulated     :     No
Primary Routes of Entry     :     Skin, Ingestion, Inhalation
Existing Conditions Aggravated by Exposure     :      Vapour Can be Irritating to Eyes, Nose, Throat  and Can Cause Headache, Dizziness, and  Nausea. Liquid is an Eye irritant.

EMERGENCY TREATMENT PROCEDURES:
    Ingestion     :     Do Not Induce Vomiting and Get Medical Attention
    Inhalation     :     Remove to Fresh Air. Call Physician
    Eye Contact     :     Flush with Water for at Least 15 Minutes and Consult Physician.
    Skin Contact     :    Wash Thoroughly with Soap and Water.
PERSONAL PROTECTION:
    Eyes     :     Wear Safety Glasses or Goggles
    Skin     :     Wear Rubber or Plastic Gloves
Ventilation     :     Sufficient to Maintain Vapour Pressure below TLV

SECTION VIII - REACTIVITY DATA

Stability     :     Stable
Hazardous Polymerisation     :     Will Not Occur
Hazardous Decomposition Products
    (Non-Thermal)     :     None Known
Incompatibility     :     Hydrofluoric Acid, Strong Oxidisers
SECTION IX - SPILL OR LEAK AND DISPOSAL PROCEDURES


Steps to be taken in Case Of Spill or Leak    :    Scrape or Wipe up as Much Material as Possible & Store in a Closed Container. Residues may be cleaned with Isopropyl Alcohol. For Large Spills Ventilate Area and Remove Sources of Ignition
Waste Disposal Method     :     Dispose of This Material in Accordance with  all Federal, State and Local regulations.

SECTION X - STORAGE AND HANDLING PROCEDURES   

Storage     :        Do Not Store Near Heat, Sparks or Flame.
Handling     :     Avoid Prolonged Breathing of Vapours and Contact with Eyes.

SECTION XI - HAZARD COMMUNICATION CODES

HMIS RATINGS:
    Health    :    1
    Fire    :    3
    Reactivity    :    0

CONTACT POINT:

POISONS INFORMATION CENTRE

Adelaide: (08) 8204-6117 Brisbane: (07) 5253-8233
Canberra: (02) 6285-2852 Darwin: (08) 8922-8842
Hobart: (02) 6338-8485 Melbourne: (03) 9345-5678
Perth: (08) 9381-1177 Sydney: (02) 9692-6111
POLICE OR FIRE BRIGADE: 000 EXCHANGE: 1100

DECLAIMER:

The Information Contained Herein is Based on Data Considered Accurate. However, No Warranty is Expressed or Implied Regarding the Accuracy of the Data or the Results to be obtained From the Use Thereof. Because the Information Contained herein may be applied Under Conditions beyond Our Control, We Assume No Responsibility for Its use.

Rev. 2/11/00

Click Here for Technical Data

< close window >