Technical Data

PRODUCT:         LOW VOLATILE AUTOMOTIVE SEALANT - RED

PART NOS:        49202, 49292

PRODUCT DESCRIPTION:

DynaGrip Low Volatile Automotive Sealant is a past like, one part material that cures to a tough rubbery solid upon exposure to moisture in the air. DynaGrip Low Volatile Automotive Sealant does not run thus making it ideal for use in either overhead or vertically. DynaGrip Low Volatile Automotive Sealant is formulated to meet or exceed OEM Volatility specifications for use near Engine Sensors.

PERFORMANCE PROPERTIES:

DynaGrip Low Volatile Automotive Sealant will not corrode or NOT adhere to Copper, Brass Magnesium, Zinc, Galvanized Metal. This sealant is NOT recommended for use on Brick, Masonry and Cement Type surfaces. During curing, product will emit an Acetic Acid type smell. DynaGrip Low Volatile Automotive Sealant has good resistance to weathering, vibration, moisture, ozone and extremes of temperature. It may be applied in sub-zero temperatures without the loss of extrusion or physical properties and is effective to –35oC. DynaGrip Low Volatile Automotive Sealant can withstand temperatures of 232oC and intermittently 315oC. At temperatures of 25oC, and a relative humidity of 50% a tack free skin will form in 20 minutes. Tooling should be complete in 5-10 minutes. Curing time increases with the thickness of the joint. Metal to metal bonds should not be more that 25mm. Adhered to glass, metals and most woods DynaGrip Low Volatile Automotive Sealant has a typical peel strength of 20lb/in2 after 72 hours curing at room temperature. When stored in a closed container at 32oC, DynaGrip Low Volatile Automotive Sealant has a shelf life of 15 months. Although an acidic odour is given off during curing, this will not harm oxygen sensors and will disappear after curing is complete. 

PROPERTY DATA:

Colour                                                                                      Red
Type                                                                                        One part Silicone Rubber
Physical Form                                                                           Non Slumping Paste
Cure                                                                                         Room Temp. Cure on exposure to Water-vapour in air.
Special Properties                                                                     Meets or Exceeds OEM Volatility Specs. Safe to use on vehicles with Oxygen Sensors.

AS SUPPLIED:

Specific Gravity @ 25oC                                                          1.04
Extrusion Rate                                                                          350
Tack Free Time @25oC and 50% RH Minutes                        10-20
Cure Time @25oC and 50% RH Hours                                   24

AS CURED:

ASTM D-2240 Durometer Hardness, Shore A Points   24
ASTM D-412 Die C Tensile Strength MPa (psi)                       2.4 (350)
ASTM D-412 Die C Elongation Percent                                   600
ASTM D-746 Brittle Point Degrees C (F)                                -73 (-100)

TYPICAL USES:

DynaGrip Low Volatile Automotive Sealant can be typically used on sealing turbo housings, Exhaust manifolds, oxygen sensors, auto trim, including fabric backed plastics and make formed in place gaskets.